Tag Archives: 10′ x 20′ Large Portable Greenhouse

A greenhouse is a structure in which you can grow plants outside using solar energy to heat it so that the air inside of the greenhouse will be warmer than the actual environment. While the idea of a greenhouse has been around since Roman times, when cucumbers were grown under sheets of mica out of season for Emperor Tiberius, the greenhouse as we know it today did not exist until the beginning of this century. It wasduring that time when plastic technology advanced to the point that a greenhouse could be made both cheaply and efficiently. Today you can construct an outdoor greenhouse for just a few hundred dollars.

First of all, kits you need are:Flour, eight 18-inch rebar sections, sledge hammer, scrap lumber, carpenter’s pencil, tape measure, storm door, ventilation fan,hammer,1od nails, four 20-foot sections of schedule 40 PVC pipe, heavy gauge wire, heavy duty staples, staple gun, greenhouse plastic.
Structions as below
1) Use your tape measure to lay out your greenhouse on the ground using flour. Then hammer your rebar supports into the ground, four on each side of the greenhouse across from each other. Your supports should be no more than 3 feet apart. For larger greenhouses (15′ x 7′ Walk-in Portable Greenhouse – Arch), add more rebar and PVC sections.
2) At the base of the rebar, lay out the scrap lumber into a frame and hammer the boards together at the corners. Use abutting joints, and wire the rest of the boards to the rebar supports with the heavy gauge wire.
3) Frame in the entrance end of the greenhouse using scrap lumber. Create a door frame and a window to hold the vent fan. Use boards to brace these supports. Hang the storm door in the door frame, and the vent fan in the window.
4) Bend the 20-foot sections of PVC into a horseshoe shape, and place the ends over the rebar supports to make your hoop frame. Create a ridgepole by stringing wire over the ridge of the greenhouse from one end to the other.
5) Cover the greenhouse with greenhouse plastic and tack it to the wood foundation at the bottom of the greenhouse. Cover the frame at the ends with the plastic. Wrap one end firmly and staple in place. On the entrance end, cut a hole in the plastic for your window and door. Tack the plastic to the wood around the window and door with your staple gun.